 |
|
ACM4CBE![]()
ACM4CBE converts one (1) 12 to 24
volt AC or DC input into four (4) independently controlled PTC protected
outputs. Outputs are activated by an open collector sink or normally open (NO)
dry trigger input from an Access Control System, Card Reader, Keypad, Push
Button, PIR, etc. The unit will route power to a variety of access control
hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders,
etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. Unit is
designed to be powered by one common power source which will provide power for
both the board operation and locking devices, or two (2) totally independent
power sources, one (1) providing power for board operation and the other for
lock / accessory power. The FACP Interface enables Emergency Egress, Alarm
Monitoring, or may be used to trigger other auxiliary devices. The fire alarm
disconnect feature is individually selectable for any or all of the four (4)
outputs |
| |
• UL Listed for Access Control
Systems (UL294),
CUL Listed - CSA Standard C22.2 No.205-M1983, Signal Equipment.
File#
BP6714.
• 12 to 24 volt AC or
DC operation (setting not required).
• Power Supply Input Options:
- One (1) common power
input (board and lock power).
- Two (2) isolated power inputs (one (1) for board power
and
one (1) for
lock/hardware power).
• Four (4) Access Control System outputs.
- Class 2 Rated power
limited outputs.
- Four (4) PTC protected Fail-Safe and/or Fail-Secure 12VDC power
outputs.
- Four
(4) PTC protected 12VDC auxiliary power outputs (unswitched).
• Red LEDs
indicate outputs are triggered (relays energized).
• Four (4) Access Control
System trigger inputs.
- Four (4) normally open (NO) inputs.
- Four (4) open collector
inputs.
- Any
combination of the above.
• Fire Alarm Disconnect:
- Fire Alarm Disconnect (latching
or non-latching) is individually selectable
for any or all of the four (4)
outputs.
-
Normally open (NO) or normally closed (NC) dry contact input.
- Polarity reversal input FACP
signaling circuit.
• Fire Alarm trigger LED indicates that the Fire Alarm
Disconnect has been activated.
• Fire Alarm output relay for triggering
auxiliary reporting devices (form "C" contact rated @ 1 amp 28VDC).
• Lifetime Warranty.
• Dimensions: 8.5"H x 7.5"W x
3.5"D.
• 1/2" and 3/4" combination knockouts.
|
|
