 |
|
ACM4E![]()
ACM4E
unit converts one (1) 12 to 24 volt AC or DC input into four (4) independently
controlled fuse protected outputs. These power outputs can be converted to dry
form "C" contacts. Outputs are activated by an open collector sink or normally
open (NO) dry trigger input from an Access Control System, Card Reader, Keypad,
Push Button, PIR, etc. The unit will route power to a variety of access control
hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders,
etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The unit
is designed to be powered by one common power source which will provide power
for both the board operation and locking devices, or two (2) totally independent
power sources, one (1) providing power for board operation and the other for
lock / accessory power. The FACP Interface enables Emergency Egress, Alarm
Monitoring, or may be used to trigger other auxiliary devices. The fire alarm
disconnect feature is individually selectable for any or all of the four (4)
outputs. |
| |
• UL Listed for Access Control
Systems (UL294),
CUL Listed - CSA Standard C22.2 No.205-M1983, Signal Equipment.
File#
BP6714.
• 12 to 24 volt AC or
DC operation (setting not required).
• Power Supply Input Options:
- One (1) common power
input (board and lock power).
- Two (2) isolated power inputs (one (1) for board power
and
one (1) for
lock/hardware power).
• Four (4) Access Control System outputs.
- Four (4) fuse
protected Fail-Safe and/or Fail-Secure 12VDC power outputs.
- Any power output may be
converted to dry form "C" relay output.
- Four (4) fuse protected 12VDC
auxiliary power outputs (unswitched).
• Red LEDs indicate outputs are
triggered (relays energized).
• Four (4) Access Control System trigger
inputs.
- Four
(4) normally open (NO) inputs.
- Four (4) open collector inputs.
- Any combination of the
above.
• Fire Alarm Disconnect:
- Fire Alarm Disconnect (latching
or non-latching) is individually selectable
for any or all of the four (4)
outputs.
-
Normally open (NO) or normally closed (NC) dry contact input.
- Polarity reversal input FACP
signaling circuit.
• Fire Alarm trigger LED indicates that the Fire Alarm
Disconnect has been activated.
• Fire Alarm output relay for triggering
auxiliary reporting devices (form "C" contact rated @ 1 amp 28VDC).
• Lifetime Warranty.
• Dimensions: 8.5"H x 7.5"W x
3.5"D.
• 1/2" and 3/4" combination knockouts.
|
|
